COMPANY NAME:         Dial Manufacturing, Inc.

                                    25 S. 51st Avenue

                                    Phoenix, Arizona  85043

                                    Tel. No.: (602) 278-1100

PRODUCT NAME:   SCALE ELIMINATOR

PRODUCT NO.:             5178

                                    5284

Ingredient/CAS Number

According to OSHA Hazard Communications Standard, (29CFR 1910.1200), this product contains no hazardous ingredients.

% By Wt.

N/A

TLV

N/A

PEL

N/A

Vapor Pressure, mm Hg:            Solid

Evaporation Rate (ether = 1):       N/A

Solubility in H²O:                        Complete

Freezing Point F:                       N/A

Boiling Point F:                          Solid

Specific Gravity H²O - 1 @25C:   Solid

Vapor Density (Air-1)60-90F:       Solid

% Volatile by Weight:                 Solid

pH@ 1%     Solution 7.0 - 7.5

pH as Distributed:                      N/A

Appearance:                              Clear glassy material

Odor:                                        Typical

Flash Point F:  Not flammable

Flammable Limits:  N/A

Extinguishing Media:                              Product is not flammable.

Unusual Fire and Explosion Hazards:      None known.

Special Fire Fighting Procedures:            None.

Effects Of Over Exposure (Medical Conditions Aggravated/Target Organ Effects,

A.      Acute (primary route of exposure) Eyes & Skin:  Results from acute toxicity testing show that the material would not be considered toxic as defined by the CPSC protocol.  However, product has sharp edges which can cause skin abrasions.

B.      Subchronic, Chronic, Other:  No available information was found.

Stability:

Stable

Conditions Contributing to Hazardous Polymerization:

None known

Incompatibility:

Strong oxidizer

Hazardous Decomposition Products:

Unknown

Conditions to Avoid:

Wet storage

Good first aid should be followed in all cases of exposure.

Eyes:

In case of contact, flush with plenty of water for at least 15 minutes.  If irritation develops, call a physician.

Skin:

Wash affected area thoroughly.  Contact a physician if irritation develops.

Steps to be taken in case material is released or spilled:

Sweep up spilled material and dispose of with other solid wastes.  Product is slippery when wet.

Waste Disposal Method:

Disposal of product should be in adherence with above described (or similarly approved) disposal procedure.  Dispose of in accordance with local, state and federal regulations.

Respiratory:

Not required

Eye:

Normally not required.

Gloves:

Rubber

Other Clothing and Equipment:

Not required

Ventilation:

Normal

Precautions To Be Taken In Handling and Storing:

Wash thoroughly after handling.  Keep container closed.  Exercise caution in the storage and handling of all chemical substances.

Additional Information:

Read and observe all labeled precautions.

Shipping Name:

Not Applicable

Hazard Class:

None

United Nations Number:

None

DOT Emergency Response Guide No.:

Not Applicable