| Material Safety Data Sheets |
MATERIAL
SAFETY DATA SHEET
|
COMPANY NAME:
Dial Manufacturing, Inc.
25 S. 51st Avenue
Phoenix, Arizona 85043
Tel. No.: (602) 278-1100 Preparation
Date: 9/29/99 |
HMIS HEALTH:
2
Moderate Hazard FLAMMABILITY:
0 Minimal Hazard REACTIVITY:
0 Minimal Hazard SPECIAL:
0
Minimal Hazard |
I. PRODUCT IDENTIFICATION
|
PRODUCT NAME:
COOLER CLEANER PRODUCT TYPE:
Evaporative Cooler
Descalant |
PRODUCT NUMBER:
Dial 5218
(Pint)
Dial 5225
(Quart)
Dial 5231
(Gallon) |
II. HAZARDOUS
INGREDIENTS - Composition contains no hazardous
ingredients.
IIA.
INGREDIENTS
|
Acid
replacement blend Blend of
anti-corrosion additives Blend of
surfactants and wetting agents Water |
Percent:
5%
.1%
.5%
70.5% |
III. PHYSICAL AND
CHEMICAL PROPERTIES
|
Appearance
& Color: Clear,
light blue color. Odor:
Little or no odor. Physical
State:
Liquid pH
of Concentrate:
<1 Specific
Gravity:
1.005, 8.39 lbs./US Gallon. Viscosity:
Not Established Water
Solubility:
100° |
Boiling
Point:
>212° F
(>100° C).
(Estimated) Vapor
Pressure:
20 mm @ 72°
F
(22° C).
(Estimated). Vapor
Density:
(Air = 1)>1. (Estimated). Evaporation
Rate:
(BuAc = 1) <1. Volatile
Percent:
85°
(Estimated). Freezing
Point:
<32° F
(<0° C). (Estimated). |
IV. FIRE FIGHTING
PROCEDURES
|
Flash
Point and Method:
None Auto
Ignition:
None. Explosion
Limits:
None. Flammability
Classification as
Defined by
OSHA:
Non-combustible. Combustion Products:
At flame temperatures the product residues will emit toxic fumes of
carbon oxides and nitrogen oxides. May,
under prolonged high temperature, also give off noxious fumes. Extinguishing Media:
Use media appropriate for packaging and surroundings. Unusual Fire and Explosion Hazards: Spilled product may present slippery
conditions. Take suitable care
with footing. Special Precautions:
Avoid personal contact with the product. Fire-Fighting
Equipment:
Use bunker gear and self-contained breathing apparatus (SCBA). |
V. FIRST AID PROCEDURES
|
Eyes: |
Remove any contact lens and
immediately flush eyes with water for 15 minutes.
Lift upper and lower eyelids to aid flushing.
Get immediate medical attention. |
|
Skin: |
Immediately flush the skin
with ample amounts of water. Remove
contaminated clothing and launder before reusing.
If irritation persists, seek medical help. |
|
Ingestion: |
Do not induce vomiting.
Give ample amounts (one glass for children and two for adults) of
water, Milk of Magnesia or milk and call a physician. |
|
Inhalation: |
If liquid is aspirated into
the lungs, remove to fresh air. If
not breathing, give artificial respiration.
Get immediate medical help. |
VI. HAZARD
IDENTIFICATION
|
Primary
Routes of Entry: |
Eye and Skin. |
|
|
Physical
Hazard: |
None established. |
|
|
Summary
of Health Hazards: |
Avoid contact of eyes or
mucous membranes, which will cause irritation. |
|
|
Acute
Exposure: |
Eyes: |
Splashing into the eye can
cause effects of pain and irritation. |
|
|
Skin: |
Contact may cause mild
irritation. (Based on an OECD
test of a main product component) |
|
|
Ingestion: |
May cause pain, nausea and
vomiting. |
|
|
Inhalation of Vapor: |
Not expected to cause
difficulty. Avoid inhalation
of mists, which can cause harm. |
|
Chronic
Exposure: |
Skin: |
Prolonged contact may cause
irritation. |
|
|
Carcinogenicity Listings: |
NTP: None, IARC: None, OSHA:
None, ACGIH: None. |
|
Signs
and Symptoms of Overexposure: |
Irritation of the eyes and
mucous membranes, redness and pain. |
|
|
Medical
Conditions Aggravated by Exposure: |
Dermatitis may be aggravated
depending on the amount and duration of contact. |
|
VII.
STABILITY AND REACTIVITY
|
Stability: |
Stable |
|
Conditions
to Avoid: |
Extreme and prolonged heat
that will cause hydrolysis with the reduction of product effectiveness. |
|
Incompatibility: |
Avoid galvanized metals that
may produce explosive mixtures of hydrogen and air. |
|
Hazardous
Decomposition: |
Not expected under normal
conditions. |
|
Hazardous
Polymerization: |
Will not occur. |
VIII.
ACCIDENTAL RELEASE MEASURES
|
Procedures
for Cleanup: |
|
|
For
Small Spills: |
Treat with soda and flush
with water. |
|
For
Large Spills: |
Dike spill with sand or soil
and recover reusable product. Neutralize
the area with soda ash and place solids in a waste container.
Wash area with water. |
|
Personal
Precautions: |
See Section 9 for personal
protective equipment recommendations.
Avoid personal contact. |
|
Environmental
Precautions: |
Avoid discharge of large
amounts to any waterway or low area. |
IX. EXPOSURE CONTROLS
|
Engineering
Controls: |
Adequate general ventilation
and control of any possible mist generation.
Otherwise, no special controls. |
|
Personal
Protection: |
|
|
Ventilation: |
No special requirements
under normal conditions. |
|
Respiration: |
Not required under normal
conditions. |
|
Eye
Protection: |
Splash-proof goggles or
eyewear recommended. |
|
Gloves: |
Rubber gloves for extensive
use. |
|
Ingestion: |
Do not ingest.
Do not use when handling food. |
|
Exposure
Limit Guideline: |
This product has no
established exposure limits. |
X. HANDLING AND STORAGE
|
Safe
Handling and Hygienic Practices: |
Do not mix
with other cleaners. Wash any
contacted skin. |
|
Storage
Requirements: |
Do not store in metal
containers, especially aluminum. Storage
in certain metal containers at temperatures above 60°
C (140° F) may result in hydrogen gas evolution.
Store below 48° C (118° F) and above freezing. |
XI. TOXICITY INFORMATION
|
Information for this MSDS
came from component data and from manufacturing experience. |
XII.
ECOLOGICAL INFORMATION
|
Although not determined, we
believe that based on the component data this product is environmentally
acceptable. |
XIII.
DISPOSAL CONSIDERATIONS
|
RCRA
Classification: |
This product has been
evaluated for RCRA characteristics and does meet the criteria of the
hazardous corrosive class, D002, if discarded in its purchased form. |
|
Volatile
Organic Compound (VOC) Content: |
None. |
|
Special
Instructions: |
Neutralize waste fluids with
soda ash and discharge into a waste treatment system according to local,
State and Federal Regulations. |
XIV.
TRANSPORTATION INFORMATION
|
DOT
Labeling: |
Not required. |
|
Proper
Shipping Name: |
|
|
Hazard
Class: |
|
|
Identification
Number: |
|
XV.
REGULATORY INFORMATION
|
OSHA
Compliance: |
This MSDS prepared according
to the 29 CFR 1919.1200 and ANSI Z400.1 Standards for the preparation of
Material Safety Data Sheets. These
standards meet the requirements of the WHMIS Format Standard. |
|
TSCA: |
Although components of this
product find listing under the Toxic Substance Control Act (TSCA), this
blended product is exempt from import/transport declarations. |
|
SARA
Title III: |
The product in its normal
packaging form is exempt under SARA Section 311 and 312 of the Superfund
and Reauthorization Act of 1986 (Title III) as defined by the EPA Hazard
Categories. |
|
CERCLA,
State and Local Planning (Reporting Qualities): |
Not required. |
|
State
Right-to-Know Compliance: |
Not required. |
|
Notice:
All information appearing herein is based upon data obtained from
the manufacturers of the components used in this formulation and/or
recognized technical sources. While
the information is believed to be correct, no guarantee or warranty of any
kind, expressed or implied, is made with respect to the information
contained herein. |